Table of Contents
Beautiful curtains have a strong pull. They bring a certain charm to the home, and they have a knack for animating every room they grace.
Unfortunately, children and pets seem to be drawn to them in a way that’s unexpected and unintended, and the results are not always pretty. That’s because they tend to pull and pull the curtains until the anchors give way and everything comes crashing down.
Children and pets are not the only guilty culprits. Sometimes, even adults, accidentally or otherwise, pull down the curtains.
Other times, it may be down to the fact that the curtain rod that you’re using is, in fact, incapable of supporting the weight of your curtains.
Dislodged curtains are wrong in and of themselves, but when they leave huge holes in your walls as they fall off, the unsavory effects are multiplied. Sometimes, the holes might be so big as to make it impossible to hang the curtains back in the same spot, effectively damaging that portion of your wall.
So, what do you do in such a situation?
Find out how to fix curtain rod pulled out of the wall in this article. We’ll walk you through the whole process and also show you how to protect your walls from holes in the future.
Fixing Curtain Rod Holes Without Patching Drywall
If you’re lucky, and the damage is not very pronounced, you can get away with simply hanging up your curtains again when they fall off the wall. Meaning that there’ll be no need to patch the drywall. Just follow these simple steps:
1. Grab Your Gear
For this task, you can’t do without these tools:
- Screws
- Screwdriver
- Needle-nose pliers
- Hammer
- Plastic drywall anchors
- Power drill
2. Disengage the Curtain Rod
Pull out the curtain rod from the brackets entirely. Check the shelves for damage and if there are any, straighten out the kinks by tapping on them gently on a flat surface.
If they’re not too stiff, you may use something lighter to straighten them out, like a rubber mallet. For damages to the curtain rod, straighten them back out with needle-nose pliers.
3. Fix The Holes
With the power drill, drill two holes where the bracket used to be. Next, use a hammer to tap an anchor into each drilled hole.
4. Attach the Curtain Mount
Place the bracket over the anchors carefully. Pay attention while doing this to ensure the perfect fit without any mistakes. Next, thread screws into the anchors through the holes of the bracket. When this is done, ensure that the bracket is completely solid by tightening the screws using a screwdriver.
5. Do It For The Other Side
Perform the above steps again for the other bracket at the opposite end of the window. You may have to do it yet again if there’s a center bracket in your curtain rod holder. Center brackets usually provide additional support.
6. Hang The Curtains Again
Once all the steps have been completed, you can mount and hoist your curtains back again. Arrange the curtains on the curtain rod and put it on the brackets.
Good to Read : Do Curtain Rods Need to Be Hung on Studs?
Fix Curtain Rod Holes With Patching Compound
If the damage to the wall is pronounced, a simple re-drilling of the holes will fall flat as a potential solution. In this case, the wall will need to be patched and provided with extra support to ensure that your curtains don’t come crashing down again at the slightest provocation.
1. Get Your Gear
These are the tools you’re going to need:
- Putty knife
- Newspaper
- Primer for drywall
- Small bowl
- Screwdriver with a flat head
- Patching Compound
- Sandpaper
- All-purpose drywall joint compound
- Drywall knife
2. Clean Up the Hole
Make the hole tidy. Remove any drywall remnants with a flat-headed screwdriver.
3. Fill Up the Hole With Newspaper
To provide additional support for the patching compound, take a cut of newspaper and fill up the hole with it. Ensure that the newspaper fits very snugly in the spot, and if there appears to be any space, or if the newspaper seems loose, add more newspaper.
4. Mix Patching Compound with Water
Pour water into a bowl, then add half a cup of patching compound. Stir the mixture into a gel. Ideally, the mixture should be stiff enough not to run but also light enough to be spreadable. Use a knife to lift some of it as a test. If it dribbles back down, mix in more patching compound.
5. Fill Up The Hole With Patching Compound
With a putty knife, fill the patching compound into the hole. It would be best to look for a precise fit; it shouldn’t spill out of the hole. When this is done, let it harden for about 30 minutes.
After that, introduce a coat of drywall joint compound to the patch and get it spread out entirely evenly. For a clean, smooth finish, get a drywall knife (about four inches), and scrape the surface till it’s flat. Let it dry and toughen up throughout the night, then apply another coat.
6. Smoothen With Sandpaper, then Paint
Use sandpaper to sand the surface when the second coat of drywall joint compound dries. Next, add a coat of drywall primer to the surface, then repaint the wall if you can.
7. Hang Your Curtains Again
Here’s the final step in the whole process. Once you’ve concluded all the preceding steps, you can proceed to hang your curtains again, confident in the knowledge that it’s been anchored solidly, ready to take on the next batch of challenges.
Good to Read : Longer Curtain for Curved Shower Rod? Size, Distance and Measurement
How To Hang Curtains Without Causing Damage To The Wall
Fortunately, there’s a way to hang your beautiful curtains without causing a single iota of damage to your walls. If you’ve already installed curtain rods on your walls, this method can also protect your wall from further damage, especially if your curtain rod has become dislodged once or twice in the past.
Specific curtain rod brackets don’t need you to drill holes in your walls just to hang your curtains. With these curtain rod brackets, all you need to do is place them on your window and with just a hammer for a tool, tap them in. Further, they are solid and durable enough to hold heavy drapes, drastically reducing the chances of the curtain rod falling off due to being overburdened.
In A Nutshell
Rods falling off walls and other curtain mishaps are surprisingly common in homes. While several factors are responsible for this, their effects are uncomfortably similar. Curtains add a layer of security, protection, and charm to a home, and a home deprived of these things may lose some of its aesthetic appeal.
In this article, based on our research, we’ve provided simple and actionable steps to take when curtain rods come unstuck to help you fix them back up with a minimum of fuss. We also included a list of necessary tools for each category of fixes to help make your work more efficient and effective. Finally, we talked about a solution that can make drilling holes in your walls a thing of the past, guaranteeing the protection of your walls for the long haul.